HITEC X2-400: DC/DC Dual Port Charger - Manual (Page 23)

21
The X2-400 incorporates a variety of systems to verify the various charge/discharge
processes and the overall state of the electronics. In case of an error, the charger will
emit an audible alarm and the screen will display the cause of the error. See the follow-
ing description of the errors and their possible causes.
Incorrect polarity connected.
Battery connection is interrupted.
Short circuit on the battery connection.
Incorrect input voltage.
The voltage of the battery pack has been incorrectly set.
The charger has malfunctioned for some reason. Contact the
Hitec RCD USA customer service department immediately.
The voltage is lower than which is set, check the number of
cells in the battery pack.
The voltage is higher than which is set, check the number of
cells in the battery pack.
The voltage of one cell in the battery pack is too low, check the
voltage of each cell.
The voltage of one cell in the battery pack is too high, check
the voltage of each cell.
An improper connection to the battery is detected, check the
connectors to insure they are properly connected.
The internal temperature of the charger is too high. Allow it to
cool down by discontinuing use.
The processor cannot control the output current, take corrective
action immediately or contact the Hitec RCD USA customer
service department.
WARNING AND ERROR MESSAGES