HITEC X2-400: DC/DC Dual Port Charger - Manual (Page 22)

Voltage
Data
Number
Capacity Type of
Battery
Start
Enter
Start
Enter
‘>3seconds’
Batt Type
Stop
Start
Enter ‘>3seconds’
DEC INC DEC INC
20
Start
Enter
Start
Enter
‘>3seconds’
For your convenience, the X2-400 has a data storage and load program that can store
up to five preset battery charge or discharge configurations. You can recall these
settings when charging or discharging without having to setup the program again. To
get to the save data screen press the BATT. TYPE/ STOP button until you see the
Save Data screen. Press the START/ENTER key to modify the menu, and use the INC
or DEC to change the parameters.
Save Data Program
Setting of the parameters in the first screen will not affect the
charge and discharge process. It is only for identifying the
specification of the battery you will create a preset for. In this
example it is a NiMH battery pack with 12 cells and a capacity
of 3000mAh. When you have completed this process press
and hold the START/ENTER key for 3 seconds to enter the
charge/discharge setup screen.
Set up the charge current in the manual mode, or the current
limit in the auto mode. Press the INC and DEC key simultane-
ously to make the current field blink to switch the charge
mode.
Set up the discharge current and cutoff voltage.
Set up the charge/ discharge sequence and cycle number.
Once you have completed the setup procedures press and
hold the START/ENTER key for 3 seconds to save the data.
Load Data Program
This program is designed to load the data stored in the “save data” program. To get to
the save data screen press the BATT. TYPE/ STOP button until you see the Load Data
screen Press the START/ENTER key to make the data field blink and press the INC or
DEC keys for at least 3 seconds to load the data.
Choose the data number you want to call back. The data you
want to call back will be displayed.
Load the data.
BATTERY DATA PRESET STORAGE AND LOAD FEATURE
DEC INC DEC INC
DEC INC DEC INC
DEC INC