HITEC ENERGY SPORT ESC SERIES - Manual (Page 11)

HELI GOVERNOR MODE: Off/Mode 1/Mode 2 [CONT.]
6. When you hear _***_ _***_ _***_ _***_, you are now in the Heli
Mode 1 program setting. If this is the setting you would like to
use, pull the throttle stick to the lowest, “OFF” position.
7. The sound will stop, indicating you have finished programming
this function and your settings are saved.
• OFF:
Default Setting.
• Heli Mode 1:
5 second delay from start to full rotor head speed.
• Heli Mode 2:
15 second delay from start to full rotor head speed.
MOTOR ROTATION: Off/ Reverse
1. Turn on your radio and set the throttle stick to the top, full “ON”
positon (100%).
2. Plug the battery pack into your controller.
3. Wait 2 seconds. You will hear 4 groups of two fast beeps. After this,
groups of 4 varying beeps, tones and melodies will sound.
4. When you hear W W W W, it indicates that you are in the Motor
Rotation program setting. The default setup is OFF. To turn this
setting on and reverse the current direction of the motor, pull the
throttle stick to the lowest, “OFF” position.
5. The sound will stop, indicating you have finished programming
this function and your settings are saved.
Note
The ESC’s Brake and Low Voltage Cutoff Type will
automatically reset to Brake Off and Reduce Power after
activating the Heli mode.