HITEC ENERGY SPORT ESC SERIES - Manual (Page 6)

ENTERING THE PROGRAMMING MODE [CONT.]
2. Plug the battery pack into your controller.
3. Wait 2 seconds. You will hear 4 groups of two fast beeps. After
this, 4 varying beeps, tones and melodies will sound that indicate
you are in a specific programming function.
BRAkE SETTING: On/Off
1. Turn on your radio and set the throttle stick to the top, full “ON”
positon (100%).
2. Plug the battery pack into your controller.
3. Wait 2 seconds. You will hear 4 groups of two fast beeps. After this,
4 varying beeps, tones and melodies will sound.
4. When you hear _ * _ * _ * _ *, you are in the Brake menu. The
default setup is “OFF”. If you want to turn on the brake, pull the
throttle stick to the lowest, “OFF” position.
5. The sound will stop, indicating you have finished programming
this function and your settings are saved.
BATTERy TyPE: NiCd/NiMH/LiPo
1. Turn on your radio and set the throttle stick to the top, full “ON”
positon (100%).
2. Plug the battery pack into your controller.
Note
Tip Tip
Tip
Refer to the Programing Tone Reference chart to
determine which function’s programming section you are
in. You can also visit the Energy ESC page on
www.hitecrcd.com to listen to the tones.
Note
You can only program and save one setting at a time.
Once you have completed programming a function, the
ESC will automatically save and exit the function. If you
need to program additional items, unplug the battery and
power on the ESC again.