HITEC ENERGY SPORT ESC SERIES - Manual (Page 12)

SWITCHING FREqUENCy: 8kHz and 16kHz
1. Turn on your radio and set the throttle stick to the top, full “ON”
positon (100%).
2. Plug the battery pack into your controller.
3. Wait 2 seconds. You will hear 4 groups of two fast beeps. After this,
groups of 4 varying beeps, tones and melodies will sound.
4. When you hear // // // //, you are at the 8kHz Switching Frequency
setting. If this is the setting you would like to use, pull the throttle
stick to the lowest, “OFF” position or;
5. When you hear \\ \\ \\ \\, you are at the 16kHz Switching
Frequency setting, if this is the setting you would like to use, pull
the throttle stick to the lowest, “OFF” position.
6. The sound will stop, indicating you have finished programming
this function and your settings are saved.
Recommended switching frequency settings:
8kHz for in-runner type motors.
16kHz for out-runner motors.
LOW VOLTAGE CUTOFF TyPE
1. Turn on your radio and set the throttle stick to the top, full “ON”
positon (100%).
2. Plug the battery pack into your controller.
3. Wait 2 seconds. You will hear 4 groups of two fast beeps. After this,
groups of 4 varying beeps, tones and melodies will sound.
4. When you hear _ ˉ _ ˉ _ ˉ _ ˉ, you are at the Low Voltage Cutoff
Type - Reduce Power setting. If this is the setting you would like to
use, pull the throttle stick to the lowest, “OFF” position or;
Note
You can change the motor rotation using one of the following
methods:
1. Swap any two motor wires.
2. Programming the ESC with a programming card or radio.