Konig Electronic Indoor pan-tilt IP camera remote video surveillance - Manual (Page 22)

ENGLISH
22
7) Why can’t uCare Cam connect with WiFi Router using WPS Mode?
a. Make sure Router’s WPS function is enabled.
b. Please try Router model if WPS mode setup failed.
8) What is the frequency of email alert and smartphone notify alert?
Ans: Once motion or sound detection is triggered, then uCare Cam will send email and
phone notify immediately. If the trigger event continually happens, then the email and
phone notify will send out on a three minute interval.
The trigger event ends after 10 seconds if there is no continual motion or sound.
The minimum interval for email and phone notify will be 11 seconds.
9) What is the estimate recording size of video per hour (video format AVI)
VGA 640x480 Continuous HQ (20fps) Continuous LQ (10fps)
Frame Rate Priority 4GB / Hour 2GB / Hour
Image Quality Priority 8GB / Hour 4GB / Hour
10) In iOS, I can not see the uCare Cam Router “wifi-cam-p2p”.
After some time, the uCare Cam Router will no longer broadcast the SSID “wifi-cam-p2p”.
Please reset uCare Cam by pressing the WPS/REST button for ~10 seconds. Then please
take note of the LED color. When the LED turns green/red, then you should see the SSID
being broadcast again.