Lab.gruppen PLM 20000Q - Manual (Page 78)

72
Back Panel Interface
PLM Series Operation Manual rev 1.2.3
When the device is connected to an active network, the yellow LINK LED illuminates above the connector in
use. Data activity on the network is indicated by illumination of the green ACT LED. It is normal for the ACT
LED to flicker either sporadically or continuously.
8.4.1 Primary Network Connection
The Primary Network connection is used for Lake Controller connectivity and Dante digital audio. Please
refer to section 4.2 for additional information.
8.4.2 Secondary Network Connection
The Secondary Network connection may be used for a redundant Dante digital audio network. Please refer
to section 4.2 for additional information.
8.5 Power Inlet
8.5.1 Power Connector
A Neutrik NAC3 Series powerCON connector rated at 32 A is fitted to the rear of the PLM for AC mains
input. The power cable (AC cord) supplied with the PLM has the mating connector ready-fitted, but may
require a mains (AC) plug specific to your country to be fitted to the other end. The wiring an pinout details
are shown in Table 8-5.
powerCON
Pin
230 V
Version
115 V
Version
L Brown Black
N Blue White
Green/Yellow Green
Table 8-5: powerCON Connector Wiring and Pinout