Lingenfelter L300046006 Lingenfelter C6 Z06 Corvette High Capacity Oil Tank 2006-2008 v1.0 User Manual
Page 10
Page 9.
26. Line up the holes on the top and bottom tank
and also make sure that the bolt holes line
up correctly. Line up the tape on the top tank
with the oil line fittings on the new lower tank.
Remember your marking that you made on
your old lower tank and compare it with the
new tank.
27. After aligning the tanks, using a 13 mm socket
and extension, torque the eight (8) bolts to
18 lb-ft in an 8-bolt star pattern (25 Nm).
Remember that you will need a deep well
socket to torque the longer bolts. The tape
used to mark the tank should be in between
the two (2) longer bolts.
28. Replace the two oil seals on the bottom oil
tank lines with the supplied oil seals (GM part
# 15217990). Make sure that the rubber side
of the seals are facing toward the tank.
29. Place the tank inside of the passenger front
fender with the tank’s expanded oil volume
section pointing towards the rear of the
vehicle.