Lingenfelter L300046006 Lingenfelter C6 Z06 Corvette High Capacity Oil Tank 2006-2008 v1.0 User Manual
Page 7
Page 6.
14. On the bottom of the tank remove the oil
temperature sensor by first disconnecting
the harness and then unscrewing the sensor
using a 19 mm wrench. Inspect the sensor
for damage as you will be using this sensor
again.
NOTE: The sensor may be removed after the
tank is removed from the vehicle instead of
while it is still in the vehicle.
15. Remove the oil lines from the bottom of the
tank by using a 13 mm wrench to remove the
two bolts directly under the oil lines. Be sure
to have an oil pan below to catch any residual
oil that may drain out of the tank.
16. At this point in the installation it is
recommended to have another person to help
remove and place the oil tank. While one
person is holding the top of the tank, remove
the two (2) 15mm bolts on the mounting
bracket on the bottom of the oil tank that
secure the tank and bracket assembly to the
vehicle.
17. Move the bottom of the tank out of the way
and remove the oil lines. Be sure to point the
lines into the oil pan as residual oil will most
likely drain out.