Lingenfelter L460105297 Lingenfelter LNC-003 Dual RPM Launch Controller v2.7 - Manual (Page 10)

Secondary
RPM
x1000 x100
Orange = +12V Secondary
RPM Activation
LNC-003
Dual RPM Launch Controller
Secondary RPM Activation, apply a
+12 volt signal to enable Secondary
Launch RPM.
Manual Transmission with Linelock & Nitrous
1
1 - Locate CPP (Clutch Position Switch) and unplug 2-wire connector.
2 - Cut wires appox. 3" back from connector.
3 - Find +12 volt Key On power source and connect to one wire of CPP connector.
4 - Splice two wires onto remaining CPP connector wire and connect one wire to #85 on Relay.
The extra wire will be used for LNC-003 Launch Controller activation.
5 - Connect terminal #86 on Relay to Ground.
6 - Connect wires cut from CPP Switch connector to Terminals #30 and #87 as shown.
Use this wiring configuration to simutaneously activate the 2-step feature and linelock
using the Clutch Switch and/or a momentary push button switch. Once the momentary
switch is released, the nitrous is enabled and is controlled by a WOT switch.
Wire color illustrated is
for 1999 TransAm
+12V
Fuse
5 Amp
85
86
30
87a 87
2 3
6
4
Ground
5
Connect wires cut from CPP
Switch connector in Step 2
to Relay as shown.
General purpose
Automotive Relay.
5 to 40 Amp
Toggle Switch
Arms Linelock
and 2-Step
Ground
Momentary
Switch
85
86
30
87a 87
Ground
Linelock
Solenoid
+12V
Ground
Optional LED, On when
Arming Switch is ON and
Clutch Pedal is depressed.
Remove Switch and
wire direct to make
2-Step active with
clutch switch only.
Relay can be omitted if Linelock Solenoid
has a lower current/amp draw than the
Momentary Switch rating.
WOT Switch
85
86
30
87a 87
Ground
To Nitrous Relay
Page 9 of 17