Lingenfelter L460105297 Lingenfelter LNC-003 Dual RPM Launch Controller v2.7 - Manual (Page 8)

Page 7 of 17
85
86
30
87 87a
C
NO NC
1 - Locate CPP (Clutch Position Switch) and unplug 2-wire connector.
2 - Cut wires appox. 3" back from connector.
3 - Find +12 volt Key On power source and connect to one wire of CPP connector.
+12V Key On Power
To LNC-003 +12V Activation
Ground
Connect wires cut from CPP
Switch connector in Step 2
to Relay as shown.
1
3
4 - Splice two wires onto remaining CPP connector wire and connect one wire to #85 on Relay.
The extra wire will be used for LNC-003 Launch Controller activation.
5 - Connect terminal #86 on Relay to Ground.
6 - Connect wires cut from CPP Switch connector to Terminals #30 and #87 as shown.
Pin #87 is the Normally Open (NO) terminal.
Wire color may vary for model/year.
4
5
6
1998-2002 F-Body and 1997-2008 Corvette Factory Clutch Switch Diagram
General purpose
Automotive Relay.
5 to 40 Amp
Wire color illustrated is for 1999 TransAm
2
WARNING: Splicing the Clutch Pedal Position Switch signal wire is required for vehicles that are equipped
with a Clutch Pedal Position Switch. For vehicles equipped with a Clutch Pedal Position Sensor, DO NOT CUT
the signal wire. Vehicles equipped with CPP sensors include 2008-2013 Corvettes and 2010-2013 Camaros.