Lingenfelter L460145297 Lingenfelter LNC-2000 LS Timing Retard Launch Controller v2.0 - Manual (Page 27)

A
B
C
LNC-2000
Red = MAP +5V
Black = MAP/Linear Ground
Purple = MAP/Linear Signal
F = Linear Mode
.2 Volt = 0*
4.8 Volt = 15*
Max Retard
LNC-2000 Receiving 0-5V Timing Retard Input from a Davis
Technologies TMS-Drag-MAP Series Traction Control Module
(With the MAP Adapter)
-Set the LNC-2000 to Linear Mode (”F” on
Timing Rate setting)
-Set the traction control module for the
desired timing retard ramp.
-Set the Max Retard setting on the LNC-2000.
-While the traction control module will
create the timing retard ramp, the LNC-2000
will still control the maximum timing retard.
The female MAP adapter connector must
either be modified or replaced because it
is keyed. There are two solutions:
- LPE sells a keyless connector to replace
the stock connector (PN: L480320000).
- Remove the terminals from the stock
connector, drill out the keys in the
connector, and then reinstall the
terminals into the connector.
The TMS-Drag-MAP
Series Traction Control
Modules are property of
Davis Technologies
Page 26 of 31