Lingenfelter L710671005 Lingenfelter Trailblazer SS & SSR Fuel Pump Upgrade Kit v1.8 User Manual
Page 4
6) Using a sharp knife or razor blade,
cut the fuel line one (1) barb down
from the end of the fuel pump. Using
a small screwdriver, or hook tool,
remove the fuel line from the last
barb. Square off the end of the fuel
line with the sharp knife or razor,
leaving enough room for the Oetiker
clamp.
7) Remove the pump from the inner portion of the fuel pump module by pushing the retaining latch out
of the way while pushing the pump up towards the top of the module.
8) Place the supplied spacer ring over the terminal end of the supplied
high flow fuel pump.
9) Install the high flow fuel pump and spacer ring assembly into the
inner part of the fuel pump module assembly, making sure the pump
inlet aligns with the cutout in the module.
10) Make sure the pump is fully seated in the module and the retaining
latch snaps over the top of the spacer ring.
11) Install the fuel sock that was removed in Step 4.
Page 3 of 5