Lingenfelter L710671005 Lingenfelter Trailblazer SS & SSR Fuel Pump Upgrade Kit v1.8 - Manual (Page 5)

13) Slip the Oetiker clamp over the end of the fuel line and push the fuel line onto the outlet of the fuel
pump. Make sure the barb on the fuel pump outlet reaches the 2nd rib on the fuel line. This will
insure that you have enough room to clamp the fuel line below the barb.
14) Using an Oetiker clamp crimping
tool, or a diagonal cutter, secure the
clamp around the fuel line.
15) Using wire cutters, cut the supplied GM fuel pump adapter wiring
harness (part # 94-615) 6” (15 cm) from the connector (as shown).
16) Using a wire stripping tool, strip roughly 1/4” (6 mm) of insulation
off of the ends of the two wires.
17) Using a wire stripping tool, strip roughly 1/4” (6 mm) of insulation
off of the end of the small ground wire that was cut from the old
fuel pump in Step 5. Join the stripped end of the small ground wire
with the black wire from the adapter harness that you stripped of
insulation in Step 16.
18) Using a terminal crimping tool, crimp
the supplied Metri-Pak terminals
on the end of the wires. As shown,
crimp the small ground wire that you
stripped of insulation in Step 18 with
the thicker adapter harness black wire
that you stripped of insulation in Step
16.
12) Install the “bucket”, making sure it is fully seated and all of the
retaining tabs are latched.
19) Using a pin tool, remove the original wires from the white connector
that attaches to the bulkhead connector on the top of the module.
Note which wire is in which cavity (red should be closest to the
latch).
Page 4 of 5