Livorsi TTK1050EL - Manual (Page 4)

Billet Trim Tab Installation
4 of 11 715 Center Street Grayslake IL 60030 P: 847.752.2700 E: [email protected] www.livorsi.com
REV B MAY 2015 TTK EL Models
Mount the tab:
If the Livorsi Trim Tabs are replacing existing tabs,
make sure to seal any unnecessary holes on the tran-
som. Use a high quality marine sealer suitable for
underwater use.
Recommended sealant: Marine Grade RTV / silicone
sealant 4200 or 5200.
Use this same sealer and apply liberally around each
fastener, indicator wires and between transom and
upper trim plate. It is recommended to apply the same
sealant to the inside of the boat.
You may want to apply a piece of tape to the ends of
the hydraulic thru hull fittings to prevent debris from
entering the openings.
If equipped with the electronic sensor carefully feed the
sensor wires thru the transom.
Secure all mounting hardware.
Installing the pumps and hydraulic lines:
Select the location to mount the hydraulic pumps.
NOTE: Keep pumps as level as possible.
Once mounted, route the hydraulic lines from the tab to the pump. Make sure hydraulic lines
are routed and secured away from any moving components in the boat..