Lumagen Radiance 2143/2123 - Manual (Page 33)

Section 8 – Miscellaneous Commands
Copyright 2009-2014 Lumagen, Inc. Radiance 2123 and 2143, Rev 041614 25
Section 8 – Miscellaneous Commands
System Settings
Menu Mode
The menu mode controls what settings can be changed in the menu. In Locked mode nothing can be
changed in User Mode, Service Mode (temporary) and Service Mode (permanent). The default setting is
User Mode, which allows access to all the basic controls. The Service Mode allows access to all controls
including the color gamut controls. The configuration can be locked to prevent unintended changes. When
locked, input selection functions normally, but setup parameters are fixed. The command is:
MENU → Other → Menu control→ Menu Mode → (Locked, User mode, Service mode
temporary, Service mode permanent)
Timeouts
In the “Normal” setting the menu and test patterns will timeout in approximately three minutes. The “Slow”
setting extends the timeout by x10. Test patterns also have a setting for “Never” timeout. The command is:
MENU 0 9 0 5 (Normal, Slow) Ok
or MENU → Other → Menu control→ Timeouts → (Normal, Slow, Never)
OSD Enable
On-Screen-Display (OSD) shown after each user command. Shows the selected input, input aspect ratio,
and zoom. The command is:
MENU → Other → Menu control→ OSD enable → (On, Off)
Input Reselect
When the currently active input is reselected the input will be reinitialized and the input number will be
displayed. The command is:
MENU → Other → Menu control→ In Reselect → (On, Off)
Menu Placement
In the “Standard” placement the menu is in the center of the screen. Choose “Center open” to move the
menu so that the center of the screen is open for display calibration measurements. The command is:
MENU → Other → Menu control→ OSD enable → Menu placement → (Standard, Center
open)
Input Menu
Displays a list of inputs you can select when the “Input” button is pressed on the remote. The command is:
MENU → Other → Menu control→ Menu Options → Input Menu → (Off, On)
Initial Power State
When power is connected, the unit will turn “on” automatically, or go to “standby-mode”. The command is:
MENU → Other → OnOff Setup → Auto On → (Standby, Turn On)
Initial Input State
Sets which input and input memory is selected when the unit is turned on, either after power has been
removed or the unit has been put into standby. The command is:
MENU → Other → OnOff Setup → Input Select→ (After Power Removed, After Standby)