Lumagen Radiance 2143/2123 - Manual (Page 40)

Section 9 – 3D Support
Copyright 2009-2014 Lumagen, Inc. Radiance 2123 and 2143, Rev 041614 32
Setup for Non-Compliant 3D Video Sources
The Radiance also has settings to display 3D video using 3D video from non-compliant video sources. It is
only necessary to manually set the 3D input mode on the Radiance if the video source doesn’t transmit that
it’s displaying a 3D mode.
1. If starting with a unit in an unknown state, press “MENU 0999” to restore factory default settings.
2. Connect the
Radiance outputs. If using only one Radiance output, use Output 1 if the Radiance
needs to pass audio, or Output 2 if not. If using an AVR, or audio Pre/Pro, connect it to Radiance
Output 1 and the display to Output 2.
3. Connect a video source that supports 3D to a HDMI input on the Radiance.
4. Turn on power to the display, Radiance and video source.
5. The Quick Key Menu has settings to set the Radiance input to 2D, 3D Side-by-Side, or 3D Top
Bottom mode, press “MENU → Quick Keys → (3D Off, 3D SbyS, 3D TopB) → Ok”.
6. The direct commands to set the Radiance input to 2D, 3D Side-by-Side, or 3D Top-Bottom is:
2D “MENU 030”
3D Side-by-Side “MENU 031”
3D Top-Bottom “MENU 032”
7. This setting isn’t saved. Use the Quick Key Menu or a direct command to set the 3D input mode on
the Radiance, when using a non-compliant 3D video source.