Undo, Restore isf calibration, Revert to factory settings – Lumagen Radiance 2143/2123 User Manual
Page 36
Section 8 – Miscellaneous Commands
Copyright 2009-2014 Lumagen, Inc.
Radiance 2123 and 2143, Rev 041614
28
Undo
Revert to the configuration over-written by the last SAVE command. Repeating the Save Undo command
toggles between the last two saved configurations. The command is:
MENU → Save → Undo → OK
Restore ISF calibration
During calibration, the video technician can save the resulting Lumagen configuration to a special hidden
configuration memory. This command restores that configuration in the event that the user inadvertently
changes the configuration. A SAVE is required to make the restore permanent. The command is:
MENU → Save→ Restore ISF→ OK
Revert To Factory Settings
Set all parameters to factory defaults. A SAVE is required to make the settings permanent. The command
is:
MENU 0 9 9 9
Or MENU → Save→ FactoryReset → OK