Lumagen VisionDVI & VisionHDP - Manual (Page 11)

VisionHDP ™
User Manual and Installer Guide
© 2004-2007 Lumagen®, Inc. 8 Rev 1.14
sync) input can be specified using component input 4 and inputs 5, 6 for HSync
and VSync respectively (MENU
→IN→TYPE→RGBHV).
Command Format
Commands are selected with the supplied infrared remote or the RS232 serial port. To prevent
possible command conflict, only one of these methods of command should be used at a time.
The infrared remote control command notation is described below:
• Remote buttons are named as shown on the remote in a bold font.
Example: MENU.
• For comma separated lists, press the buttons in the sequence shown.
• For parenthesized lists, select one button from the list.
• For square-bracketed lists, press the buttons as needed.
Example: For the list […, †, ‡, ˆ], press the arrow keys as needed.
• For menu commands press the MENU button. The ‡ and ˆ arrow keys are used to select
the function. The † arrow key (or OK) is used to enter sub-menus. This is shown as: MENU
→ MenuItem → MenuItem. The … arrow key (or EXIT) steps up one menu level.
• Numerical entries are listed as value. While entering the value, the … arrow key acts as a
backspace key.
• Some commands are activated immediately. Other commands must be explicitly accepted by
pressing OK. If needed, OK is listed as part of the command.
• Pressing EXIT cancels a partially completed command. If the menu system is active, EXIT
returns to one level higher in the menu system.
• There are four independent configuration memory types for each input (MEMA , MEMB,
MEMC and MEMD). The input setup and output resolution/timing can be set independently
for each memory. Note that, initially, there is a single output mode for all configuration
memories. To program an input memory, first select the input, then select the desired
configuration memory and use the menu system to configure.
• Some menu commands are only available when their respective input is selected.
• Before changes are saved, they can be discarded by entering standby mode.
• To prevent unintended configuration changes, before saving, use the lock command.
• Save the configuration after making changes, otherwise the changes will be lost when
entering STBY mode.
If the serial port is used, the ASCII character associated with the respective remote control
button must be sent. See the Serial RS2323 Command Interface section (page 28) for
information on serial commands.