Installation commands, User manual and installer guide, Output configuration – Lumagen VisionProHDP User Manual
Page 17: Visionpro hdp
VisionPro HDP
™
User Manual and Installer Guide
© 2004-2006 Lumagen®, Inc.
14
Rev 1.1
Installation Commands
See the Command Format section (page 8) for a description of the installation command
interface.
Output Configuration
The factory-default is 480p at 59.94 Hertz, with a 1.78 (16:9) aspect ratio. For analog
output, the default mode is RGBH-V-. See the Selecting the Output Resolution section
(page 31) for more information on which output resolution to use. If more than a single
output resolution is required, see the Multiple Output Mode section (page 32).
Note:
If the analog output is enabled, it is turned off for HDCP encrypted sources.
Display Type
By default (Auto), if a DVI-D display is detected, DVI-D output is enabled, and analog
output is disabled. If no DVI-D display is detected, analog RGBHV output is enabled,
and DVI-D is disabled. The output can also be manually selected. If both are enabled, the
analog output must be one of the RGB types. The commands are:
Auto:
MENU
0
9
3
2
1
Output DVI-D only, if detected
,
else analog only
DVI-D only:
MENU
0
9
3
2
2
DVI-D only, even if DVI-D is not detected
Analog only:
MENU
0
9
3
2
3
Analog only, even if DVI-D is detected
Both:
MENU
0
9
3
2
4
Output DVI-D and analog RGB
The following commands select the output color-space and synchronization type for the
analog output. The selection takes effect immediately. The arrow buttons are then active
and have immediate effect. If no arrow buttons are pressed the default mode is used.
Press the
OK
button when done to prevent the arrow buttons from continuing to change
the sync type.
RGBHV:
MENU 0
1
2
[
ˆ
,
‡
]
[
…
,
†
]
OK
ˆ
sets both H and V sync as negative (default)
‡
sets both H and V sync as positive.
…
sets negative H sync. If needed, select after the
ˆ
or
‡
button.
†
sets positive H sync. If needed, select after the
ˆ
or
‡
button.
RGBS:
MENU
0
1
3
[
ˆ
,
‡
]
OK
ˆ
sets negative composite sync (default)
‡
sets positive composite sync
RGsB:
MENU
0
1
4
[
ˆ
,
‡
]
OK
ˆ
sets embedded bilevel sync
‡
sets embedded trilevel sync (default)
HD color-space YP
R
P
B
:
MENU
0
1
1
[
ˆ
,
‡
]
OK
ˆ
sets embedded bilevel sync
‡
sets embedded trilevel sync (default)
SD color-space YP
R
P
B
:
MENU
0
1
5
[
ˆ
,
‡
]
OK
ˆ
sets embedded bilevel sync (default)
‡
sets embedded trilevel sync