User manual and installer guide, Visionpro hdp – Lumagen VisionProHDP User Manual
Page 18
VisionPro HDP
™
User Manual and Installer Guide
© 2004-2006 Lumagen®, Inc.
15
Rev 1.1
Vertical Output Resolution - Presets
Select one of the preset output vertical resolutions. The only interlaced format supported
is 1080i. The command format for each resolution is:
480p:
MENU 0 2
1
OK
540p:
MENU 0
2
2
OK
600p:
MENU 0
2
3
OK
720p:
MENU 0
2
4
OK
768p:
MENU 0
2
5
OK
840p:
MENU 0
2
6
OK
1080p:
MENU 0
2
7
OK
1080i:
MENU 0
2
8
OK
Vertical Output Resolution - Programmable
Manually set the output vertical resolution from 480p to 1080p, in scanline increments.
To select between 1080p, 1080i, and 1080sF24, select 1080 lines and then use arrow
buttons to selected correct format. 1080p output also allows the choice between two
modes. MODEA follows the SMPTE standard. MODE B is required for some 1080p
devices, such as the JVC™ HD2K™ projector. Out of range values are ignored. The
command format is:
MENU 0
3
value
OK
or
MENU
→
OUT
→
RES
→
VRES
→
value, [
ˆ
,
‡
]
OK
Vertical Output Refresh Rate
Set the vertical refresh rate. The range is 23.98 (DVI-D), to 120 Hertz in hundredths (e.g.
75.00 is entered as
7
5
0
0
). The maximum refresh rate depends on the output resolution.
For DVI-D Segmented-Frame (sF) output format, select 1080 lines and then select 24sF
(or 25 sF). Out-of-range values are ignored. The command format is:
MENU 0
4
value
OK
or
MENU
→
OUT
→
RES
→
VRATE
→ value
OK
Horizontal Resolution for DVI Output
For DVI-D output, use this command to set the active horizontal resolution if the HRES
selected by the Lumagen does not match the display. The command format is:
MENU 0
7
value
OK
or
MENU
→
OUT
→
RES
→
HRES
→
value
OK
Horizontal Refresh Rate for Analog Output
Note: Generally this command should not be used.
Set the analog output horizontal refresh rate in Hertz. The vertical total scanline count is
adjusted to achieve the specified horizontal frequency, if possible. The active vertical
resolution is not changed. Out-of-range values are ignored. The command format is:
MENU 0
5
value
OK
or
MENU
→
OUT
→
RES
→
HRATE
→
value
OK