Lumagen VisionProHDP - Manual (Page 28)

VisionPro HDP
™ User Manual and Installer Guide
© 2004-2006 Lumagen®, Inc. 25 Rev 1.1
Lock the Configuration
The configuration can be locked to prevent unintended changes. When locked, the input
selection functions normally, but setup parameters are fixed. The command format is:
MENU → MISC → LOCK →
( UNLOCKED , LOCKED) OK
The following command can be used to unlock the configuration memories if the on-
screen menu cannot be displayed.
MENU 0 9 1 5
Same as
MENU →
MISC
→
LOCK
→
UNLOCKED
OK
Test Patterns
Warning:
Test patterns can cause screen burn-in if left on-screen for more then a few seconds.
Activate test pattern. The … and † arrows select the test pattern. The intensity is adjusted
from 10 to 100 IRE, in 10 IRE steps, using the ‡ and ˆ arrows. The command format is:
MENU → MISC → TPAT → OK [ … , † , ˆ , ‡ ]
Menu Timeout
The MENU timeout can be changed with the following command:
MENU 0 9 0 5
Toggle menu timeout. Short (default) or long
Front Panel LCD Function
By default the front panel LCD is illuminated for a short time after a command and then
turned off. This behavior can be changed so the LCD light stays on while the unit is on.
The command is:
MENU 0 9 2 5
Toggle LED as "activity" (default) or "power."
Zoom Step
A smaller zoom step of about 5% can be selected instead of the normal step of about
15%. The command format is:
MENU 0 9 2 3
Toggle zoom-step between default and 5%.
Sidebar Pan
To help reduce screen burn-in with 4:3 sources on widescreen displays, the output can be
slowly moved left and right a fractional pixel step every few minutes. The command is:
MENU 0 9 8 7
Toggle Sidebar-pan for anti-burn. Default = off.