LW Measurements BWS NTEP Weighing Platform Scale 500lb - Manual (Page 8)

BW/BWS Series Indicator Technical Manual
- 5 -
Installation

Place the Indicator on a table or use indicator holder to connect with stand.

Connect the plat form load cell cable in to the indicator load cell connecter.
Load cell connecter is locating back side of the indicator.

Connect the adaptor pin in to the indicator adaptor jack.
Adaptor jack is locating, back side of the indicator.

Adaptor connects into your AC power socket.
Pluggable equipment must be installed near an easily accessible socket
outlet with a protective ground/ earth contact.

Turn on the On/Off key. If you want to turn off, press the key again.

Display will be show the scale capacity and will be starting self checking.

After self checking, display will be come to normal weighing mode.

Warm-up time of 15 minutes stabilizes the measured values after
switching on.

Calibrate with exact calibration weights, minimum 1/3 of the scale capacity
want to use for calibration. For calibration see details in parameter.
Then you can start your operation