LW Measurements PRW - PLUS 2 - Manual (Page 20)

PRW serial bench scale user’s manual
-17-
SECTION 12 TECHNICAL PARAMETERS
Press UNIT key and M+ key together when normal weighing mode, display shows
“F0 H-L”, press TARE key until display shows “PrOG”, press ZERO key, display
shows “PIN”, You can press G/N、UNIT、ZERO key to enter setting mode, press Tare
key to select parameter, press Zero key to sure, press UNIT key to escape.
FUNCTION SUB-FUNCTION DESCRIPTION
P1 REF
AZN 0 This option is used to select the auto zero
maintain; Options : 0.5d, 1d, 2d, 4d
0-AUTO This option is used to select the auto zero range
when turn the indicator.
Options : 0%, 2%, 5%, 10%, 20%
0- RANGE
This option is used to select the manual zero
range when press the ZERO key.
Options: 2%, 4%, 10%, 20%, 50%, 100%
speed
Set ADC speed, press U. Wt. Key to select ADC
speed, press Tare key to enter
7.5: 7.5 times per second
15: 15 times per second
30: 30 times per second
60: 60 times per second
Note: 15 times per second or 30 times per
second are recommendatory
P 2 CAL DECI
This option is used to select the decimal
Options : 0, 0.0, 0.00, 0.000
INC
This option is used to select the division
Options : 1, 2, 5, 10, 20, 50
CAP
This display will show xxxxxx for setting the
capacity.
CAL linear
Calibrate, see detail in section 10.
nonlin
P3 P RO TRI
This display will show xxxxxx for trimming the
load cells, see detail in service manual.
COUNT
This display will show xxxxxx for indicating the
internal counts.
RESET This display will show SURE for recovering the
factory default setting.
P4 CHK Mode 1
This is mode of the natural scale
Mode 2 This is animal scale
Scale can lock reading when little unstable
MODE 3 This is a subtration scale (print out “-“ weight)
M+ format:
GROSS: 0.888KG gross for gross weight
NET: 0.222KG net for net weight
TARE: 0.666KG tare for tare weight