MOCET IP Commander - Manual (Page 28)

Page 28
IP Commander for iOS VoIP User Manual
5. DECT Handset Operation (for IP3092D Series)
Communicator IP3092D series models include a DECT Base Station inside which
supports DECT GAP and CATiq-2.0 compatible handsets. Up to five handsets can
be supported on the DECT-enabled Communicator. These handsets can make and
receive calls from the VoIP service if configured to do so.
5.1 DECT Handset Register
Up to five DECT handsets can be registered to an IP3092 DECT model communicator.
The procedures of DECT registration vary and are dependent on the brand and model
of handset used. Please refer to the manual for the specific handset that you are
using.
To register a CATiq-2.0 compliant DECT handset with Communicator, You may enter
the Register Mode in Setting Menu of IP Commander:
1. Select “Settings” command from the main menu.
2. Select “DECT Settings” from the sub-command area
3. Select “DECT Handset Status” from the sub-command area
4. Press “Enter Register Mode” on the sub-command area, then the DECT base
station is entering the Register Mode.
5. Put the DECT Handset to enter the register mode at the same time.
6. Once the DECT handset is registered successfully, the status of the corresponding
DECT handset will be displayed and shown “Registered”
Enter the Register mode: Settings -> DEC Settings ->DECT Handset Status