MOCET IP Commander - Manual (Page 36)

Page 36
IP Commander for iOS VoIP User Manual
6. Voicemail box in mini-PBX (for IP3092D Series)
An internal voicemail box is created for the DECT system in the Communicator. All
the extensions including base and DECT handsets share the same voicemail box in
the embedded mini-PBX. The voicemail box allows a caller to leave a message if a
person is not available at the extension. When dialing into the mailbox, a user can
record a mailbox greeting or read the left voice messages. The greeting is played
when they are not available to take a call and a caller reaches their mailbox. The
password to access the voice mail box is “1111”.
6.1 Voicemail Settings
To configure the internal voicemail box, please follow the following steps:
1. Select “Settings” command from the main menu.
2. Select “Local Voicemail Settings” from the sub-command area
3. There are four settings in the sub-command area for voicemail box setting:
 No Answer Forwarded to Local Mailbox: (Enable or Disable)
When enabled, an incoming call will be forwarded to the voicemail box for
leaving message after the ringing is timeout.
 Mailbox ID: To specify the dial number that you can dial in the voicemail box
from base or DECT handsets. The default dial number is “1111”.
 Mailbox Pin Code: When a user dial in the voicemail box, an IVR will ask the
user to input pin code. Only the input pin code is matched with the setting
here, then the user can enter the voicemail box for hearing leaved message or
recording greeting message.
The default pin number is “1111”.
 No Answer Time(sec): Set the timeout timer. When the ringing of incoming
call is over this time, the call will be transferred to voicemail box
4. Press “Save” to confirm the settings