Pitney Bowes AnySite - Manual (Page 31)

AnySite v9 Install Guide 31
Final System Configuration
Before launching AnySite for the first time, you must complete the steps in the following sections:
 Launch the Configurator
 Import Repository Transfer (ART) Files from your Data
 Cataloging System Data if Stored to a Non-Default Location
These settings are made in the Configurator, which is a utility for managing your AnySite installation.
If you installed AnySite to a network location, so that the AnySite Client is on a different machine, then perform all of
these steps on each client machine.
Determine Which ART Files to Import
Determine which ART file to import relative to the data your purchase and are licensed for. You must import the corre-
sponding ART files used in the Configurator. In addition, existing clients who wish to migrate custom files should include
their custom file for importing ART files. See Chapter 5 Upgrading Your Current Installation instructions of backing-up
and migrating custom files from previous versions of AnySite.
Launching the Configurator
To launch the AnySite Configurator and complete the setup of your installation:
1. Either click the AnySite Configurator icon on your desktop or click Programs > MapInfo > AnySite XX > AnySite
Configurator in the Microsoft start menu.
2. The Login dialog opens.
Enter the default user name and password when prompted: type, Administrator for the username and leave the pass-
word blank. Click OK to proceed. Usernames are case sensitive, so make sure Administrator has a capital “A”.
The Cataloger, a utility accessible from the Configurator, will scan several settings for AnySite; you may receive a mes-
sage that the Cataloger will adjust these settings. If at a later time you receive this message, rerun the Cataloger as
described under Cataloguing System Data if Stored to a Non-Default Location on page 32.
3. The AnySite Configurator opens.
Proceed to Importing Repository Transfer (ART) Files from your Data on the next page.
After installing your license file, you must import repository transfer (ART) files, which contain reports, Thematics,
and other settings. Reports are data dependent. If you run a report and you have not purchased the accompany-
ing data for the report, then a “data not licensed” message appears.
If you installed StreetPro®, then select its data directories for cataloguing. The default StreetPro location is
C:\Program Files\MapInfo\Professional X.X\SPXXXX. If you installed AnySite to a network location, so that the Any-
Site Client is on a different machine, then select the AnySite installation directory (which will be a mapped drive). If
you could not use the same drive letter when mapping drives on the client machines, then you must also select the
Use UNC Paths check box.
Ensure that the Update Layer Paths check box is selected to fix any invalid paths, and then click OK.