Rocktron Utopia B200 - Manual (Page 10)

10
Press the UP button once to move one preset bank up or press and hold down the button to auto-
scroll UP. Note that once you have reached your desired preset, the preset name on the screen
will be flashing but NOT recalled. The original preset will still be active. Now select any preset
1-3 to recall or activate the desired preset.
10 DOWN button
This button allows you to scroll DOWN through the preset banks and functions in the same man-
ner as the UP button (point 9).
11 PRESET button 1
This button allows you to select presets 1, 4, 7, 10, 13, 16, 19, 22, 25, 28, etc.. When you are in
Bank 01 this button allows you to select preset 4. When you are in Bank 02 this button allows
you to select preset 7 and so on. Note that there is no 0 (zero) preset. When in "2nd" mode, this
button is used to turn On/Off the EFFECT that has been assigned to the preset selected.
12 PRESET button 2
This button allows you to select presets 2, 5, 8, 11, 14, 17, 20, 23, 26, 29, etc. When you are
in Bank 00 this button allows you to select preset 2. When you are in Bank 01 this button al-
lows you to select preset 5 and so on. When in "2nd" mode, this button is used to turn On/Off
the MUTE/TUNER Function. This will mute the output of the B200 and allow you to tune in
silence.
13 PRESET button 3
This button allows you to select presets 3, 6, 9, 12, 15, 18, 21, 24, 30, etc. When you are in Bank
00 this button allows you to select preset 3. When you are in Bank 01 this button allows you to
select preset 6 and so on. When in "2nd" mode, this button is used to activate the TAP function
and set the DELAY Rate by tapping the button at the desired rate.
14 2nd Button
This button allows you to enter the 2nd Function Mode. In the 2nd Function Mode you can use
button 1 (EFFECT ON/OFF) to turn on and off a pre-assigned effect within the preset. You can
also access the MUTE/TUNER function using button 2 and set the delay rate within a preset us-
ing the TAP button (button 3). To Exit 2nd Function mode, press the 2nd Button.
15 EXPRESSION PEDAL switch
To activate the Expression pedal, apply pressure to the toe of the expression pedal until this
switch is activated. You will know the pedal is active as you should be able to feel the switch
activate, but if not, the PEDAL ACTIVE LED will light when the switch is turned ON.
16 INPUT jack
This standard, mono 1/4" jack is used to provide input to the unit.
17 OUTPUT RIGHT jack
This 1/4" jack provides the right output of the UTOPIA B200 for use in stereo situations, such as
direct recording, plugging into a PA system, two Bass amplifiers, etc.
3. UTOPIA B200 Top and Back Panels....continued.....