Rocktron Cyborg Delay - Manual (Page 12)

LED Display
The Cyborg’s LED Display consists of 8 LEDs that are used to
visually show the user:
1) The PRESET selected
2) The TIME parameters available to the selected preset (called TIME CONTROL)
3) The TAP BUTTON parameter setting for the selected preset
4) The LEVEL setting (MIN through MAX) of each of the preset’s parameters for
the Time Control knob (point 3), the Repeat Control Knob (point 4) and the Level
Control knob (point 5).
As an example, lets choose preset 1. First, turn the Preset Knob (point 1) until the
LED under the number 1 lites. You now have selected Preset 1. On Preset 1 you
have the following parameters available
1) TAP BUTTON - The parameter available on Preset 1 is an 1/8 note parameter.
This means that on Preset 1 the Cyborg will measure on half of the time between
taps to set the delay time when using the TAP/STORE footswitch to determine the
delay time.
2) TIME CONTROL - The Time of the delay for this preset is 0ms-500ms. This
time can be selected by either using the Time Control knob (point 3) or the TAP/
STORE button. When using the Time Control knob, the LEDs in the LED Display
will start lighting from left (MIN) to right (MAX) as you increase the delay time.
The LEDs will turn off from right to left as you decrease the delay time. Addition-
ally the blue STORE LED will flash at the delay time selected.
NOTE: When using the TAP/STORE button the delay time change will only be indicated by the flashing of the
STORE LED. This LED will flash quicker when a short delay has been tapped or will flash slower when a
longer delay has been tapped. At this point, if you turn the TIME Control one click the LED DISPLAY will
immediately show you if the delay is long or short by how many LEDs light on the display.