Rocktron Cyborg Delay - Manual (Page 9)

Preset Select Knob - this knob allows you to select the “preset” you desire.
Eight presets are available with this control. As the knob is turned the LED
under the selected preset will light.
LED Display - see following page for detailed descriptions of display.
Time Select Knob - this knob allows you to increase or decrease the delay
time of the preset.
Repeat Knob - this knob allows you to select the amount of times the delay
signal will “repeat” itself. As you turn the knob you will note that the LEDs
in the LED display will light in order from left to right as you increase the
amount of repeats. As you decrease the amount of repeats the LEDs will turn
off from right to left.
Level Knob - this knob determines the “volume” of the delay relative to the
dry signal. As you increase the delay volume the LEDs in the LED display
will light in order from left to right and stay lit. As you decrease the volume of
the delay the LEDs will turn off from right to left.
DC OnTap Power input. Use the supplied Rocktron DC OnTap adapter to
power your Cyborg pedal. Plug into a standard wall outlet and follow all
safety precautions.
Input Jack - plug your guitar into this jack. See preceeding pages for
standard connections.
HUSH Switch - The Cyborg Digital Delay pedal includes Rocktron Patented
Digital HUSH noise reduction. Select “ON” if the Delay pedal is placed after
a noisy distortion pedal. Select “OFF” when using clean tones. For more on
the HUSH and how it works, see the HUSH Section of this manual.
1
2
3
4
5
6
7
8
Descriptions