Rocktron Cyborg Delay - Manual (Page 17)

MIDI
The Cyborg Delay pedal has a MIDI jack that allows you to access an additional 56
user presets. Using the Rocktron MIDI Breakout cable (sold separately) you can
access these additional 56 presets (64 total) by using a Rocktron MIDI Controller
such as the Rocktron MIDI XChange, MIDI Mate or All Access. This will also
allow you to connect and control additional Rocktron Cyborg pedals.
Note that 63 presets on the Cyborg Delay may be modified and stored (note that
preset 6 - HOLD - cannot be programmed from the front panel). When using the
option MIDI Breakout cable to access the remaining 58 presets you will find that
these locations have the original factory presets already stored. Example: Preset
1-8 are repeated in MIDI recall locations, 9-16, 17-24, 25-32, 33-40, 41-48, 49-56
and 57-64. Also note that the preset locations 1-64 will be recalled when receiving
program changes 65-128 thus allowing all MIDI program changes 1-128 to be
accepted
See MIDI connections using the optional MIDI Breakout cable on the following
pages.
Connect Midi X-change to CYBORG using the optional Midi Breakout cable
as shown in MIDI Connection 1 and 2.
1) To program any preset simply recall the preset to be programmed with your
MIDI CONTROLLER.
For Example, preset 32...
2) Now adjust preset with control knobs to make your desired changes.
3) Once you have created your preset press and hold down the TAP/STORE
Button on the Cyborg pedal until the led indicates the store process is
completed. (LED will hold bright then return to Tap Delay blinking status)
Cyborg MIDI Preset Programming