Rocktron Cyborg Delay - Manual (Page 13)

3) The LEVEL setting parameter shows the LEVEL settings of the following
parameters:
o The Time Control Knob (Point 3). Turning the Time Control knob will light
LEDs in the display to show you the Delay time length that you have selected
within the preset. To see the current delay time of the preset , turn the knob only
one click. This will cause the LEDs to light showing your current setting. To
change the setting continue turning the knob. Turning the knob clockwise will
increase the delay time and the LEDs will light from left (MIN) to right (MAX). To
shorten the delay time turn the knob counter-clockwise and the LEDs will turn off
from right (MAX) to left (MIN).
o The Repeat Control Knob (point 4). Turning the Repeat control knob will light
LEDs in the display to show you how many “repeats” of the delay are selected
within the preset. To see the current number of repeats for this preset, turn the knob
only one click. This will cause the LEDs to light showing your current setting. To
change the setting continue turning the knob. Turning the knob clockwise will
increase the amount of repeats and the LEDs will light from left (MIN) to right
(MAX). To decrease the amount of repeats turn the knob counter-clockwise and the
LEDs will turn off from right (MAX) to left (MIN).
o The Level Control Knob (point 5). Turning the Level Control knob will light
LEDs in the display to show you level of the delay of the preset relative to the
unaffected dry signal. To see the current level for this preset, turn the knob only one
click. This will cause the LEDs to light showing your current setting. To change
the setting continue turning the knob. Turning the knob clockwise will increase
amount of wet (effected) signal relative to the dry (unaffected) signal and the LEDs
will light from left (MIN) to right (MAX). Turning the knob counterclockwise will
decrease the amount of wet signal relative to the dry signal and the LEDs will turn
off from right (MAX) to left (MIN).