ROHO Retrobac System - Manual (Page 6)

To Remove The Cover:
1. Remove the Retroback from the wheelchair.
2. Pull open the Velcro flap sections on the top edge of the Retroback cover.
3. Pull the foam pad out of the cover’s front foam section.
4. Unsnap both of the snaps holding the back clip in place.
5. Slide the back clip out of the cover’s back clip section.
To Replace The Cover:
1. Lay the cover on a flat surface with the Velcro top open and the back clip
section facing up (two metal snaps should be visible).
2. Hold the back clip so the Retroback logo is facing up. Slide the open
bottom of the back clip into the cover’s back clip section so the non-logo side
of the back clip rests between the snaps. Note: The side of the clip with the
Retroback logo should still be visible on the outside of the cover. Press the
snaps together to entrap the back clip (see diagram for snap location).
3. Turn the cover over so the clip is now facing down. Slide the foam pad into
the front foam section. Note: The "Top" label should be visible after the foam
pad is in place. Close the two side sections of the Velcro flaps, followed by the
center sections to secure the foam pad.
The Retroback is now ready for attachment.
COVER REMOVAL & REPLACEMENT
4
Side View