SkyRC iMAX B6 Mini Charger - Manual (Page 12)

Failure to connect as shown in this
diagram will damage this charger.
To avoid short circuit between the
charge lead always connect the
charge cable to the charger first, then
connect the battery. Reverse the
sequence when disconnecting.
WARNING:
OPERATING PROGRAM
Here is the detailed procedure to make the charger work. All the screens and
operations will take Li-Po BALANCE CHARGE program for example,
1. Connection
Connecting to power source
Please connect SKYRC B6 mini with AC Adaptor or AC/DC power supply by
supplied DC input cable. Also you could use terminal clips with DC connectors,
for attaching directly to 12V car batteries.
It is critically important that you use either a fully charged 13.8V car battery or a
high quality AC Adaptor or AC/DC power supply in the range of 11-18V DC
output with minimum current rating of 6A to insure reliable performance.
Connecting the battery
Important!!! Before connecting a battery it is absolutely essential to check one
last time that you have set the parameters correctly. If the settings are
incorrect, the battery may be damaged, and could even burst into flames or
explode. To avoid short circuits between the banana plugs, always connect the
charge leads to the charger first, and only then to the battery. Reverse the
sequence when disconnecting the pack.
Balance Socket
The balance wire attached to the battery must be connected to the charger
with the black wire aligned with the negative marking. Take care to maintain
correct polarity! (See the wiring diagram below.)
This diagram shows the correct way to connect your battery to the SKYRC B6
mini while charging in the balance charge program mode.
1).
2).
3).
It is for lithium battery in all mode.
· 10 B6 mini