Ount on, Eavy, Tand and – Southbend Platinum Steakhouse Broiler User Manual

Page 7: Ttach, Estraint, Installation of restraint

Advertising
background image

OWNER’S MANUAL 1190950 REV 2 (11/14)

PAGE 7

OF 22

S

TEAKHOUSE

B

ROILER

S

TEP

2

A:

M

OUNT ON

H

EAVY

D

UTY

S

TAND AND

A

TTACH

R

ESTRAINT

The stand is crated separately, but is shipped with the broiler. Depending on the shipping requirements, the broiler may

already be assembled to the stand.

I

NSTALLATION

NOTICE

For an appliance equipped with casters, (1) the installation shall be made with a connector that complies with the

Standard for Connectors for Movable Gas Appliances, ANSI Z21.69 or Connectors for Moveable Gas Appliances,

CAN/CGA-6.16, and a quick-disconnect device that complies with the Standard for Quick-Disconnect Devices for

Use With Gas Fuel, ANSI Z21.41, or Quick Disconnect Devices for Use with Gas Fuel, CAN1-6.9, (2) adequate

means must be provided to limit the movement of the appliance without depending on the connector and the quick-

disconnect device or its associated piping to limit the appliance movement, and (3) the restraining means should be

attached to a frame member on the back of the appliance.

1. Secure the restraining-cable bracket (item “B” in Figure 4) to a wall stud located as close as possible to the connection

point of the gas-supply line (and the pressure-regulator vent line, if a vent line is in use). Use four #12 screws (items

“C”) and plastic anchors (items “A”), if necessary.
2. Install eye-bolt (item “F”) to a frame member on the rear of the appliance. After checking carefully behind the frame

member for adequate clearance, drill a 1/4” hole through the frame member.
3. Thread hex nut (item “G”) and slide the washer (item “H”) onto the eye-bolt. Insert the eye-bolt through the 1/4” drilled

hole and secure with a washer (item “H”) and nylon lock nut (item “I”).
4. Using the spring-loaded snap hooks, attach the restraining cable to the bracket and the eye-bolt.
5. Using the cable clamp (item “D”), adjust the restraining-cable extended length to prevent over-bending or kinking of

the gas line (and vent line, if in use).

Figure 2

Installation of Restraint

D

E

A

B

C

F

G

H

I

Advertising
This manual is related to the following products: