Southbend EZ24-5 - Manual (Page 22)

INSTALLATION AND OPERATION MANUAL, PAN STEAMERS, MODELS EZ24-3, EZ24-5
MANUAL 1195731 rev0 (11/22/2011) 22 HEAVY DUTY STEAM
8.0 TROUBLESHOOTING (Continued)
Wiring
WARNING: Disconnect the power supply to the appliance before
cleaning or servicing.
Using an ohmmeter, wiring continuity between the connections shown on the wiring diagram is
readily verified. This is best done in stages, removing only those wires required for each
continuity check. As each lead is replaced, it should be checked for evidence of corrosion, and
cleaned if necessary. All leads must be tightly attached so as to provide a good electrical
connection.
Door Gasket
Check gasket for cuts and replace if necessary.
Door Gasket Replacement
The cooking compartment door gaskets are made of a silicone-type rubber material that is very
durable but subject to wear during normal operation. Should the gasket leak replace it.
1. Open the cooking compartment door.
2. Remove the six or eight screws from the gasket plate in the door panel assembly.
3. Remove the gasket plate and the door gasket from door panel.
4. Install the new door gasket to the door panel. Replace the gasket plate and six or eight
screws.
5. Gasket replacement is now complete.
Door may be difficult to close until gasket has compressed to conform to opening. Leaving
door closed overnight will compress gasket.