Speck Electronics EQ16 - Manual (Page 13)

There are 5 terminals available on the power transformer of the power
supply. The configuration of the five terminals determine the operating
voltage of the power supply. It is only necessary to change the black
(line) and white (neutral) AC wires. Do not attempt to remove or
change the Green AC safety wire or the multicolored wires used at
the DC terminals. It is recommended that you measure the DC
voltages at the DC connector before reconnection to the mixer.
The following chart represents the proper AC terminal configuration for
the Model PS3-0.8 and PS3-1.5 power supply.
The following chart represents the proper fuse rating for the Model PS3
power supplies. All fuses are 5 x 20mm Slow-Blow type.
Before connecting the DC power supply connector to the Model EQ16,
make certain the power supply is not plugged in.
The power supply interface cable is a 3 conductor wire with a square
plug on each end. Do not attempt to extend or modify this cable. Any
attempt to modify this cable could result in severe damage to the EQ16
or power supply.
To connect the power supply to the mixer, first fit the square plug into
the receptacle on the power supply. The connectors are keyed so they
will only fit in one direction.
AC wiring chart
Connecting the
Power Supply
9
Fuse chart
CAUTION! ALWAYS VERIFY THE PROPER OPERATING VOLTAGE
FOR USE AT:
JUMPER AT:
APPLY A.C. AT:
120 VAC
1 & 3
2 & 4
4 & 1
220 VAC
2 & 3
1 & 5
230 VAC
2 & 3
4 & 1
240 VAC
2 & 3
4 & 1
100 VAC
1 & 3
2 & 4
5 & 1
.75 AMP
.75 AMP
.375 AMP
.375 AMP
.375 AMP
100 VOLTS AC
120 VOLTS AC
220 VOLTS AC
230 VOLTS AC
240 VOLTS AC
MODEL PS3- 0.8
1 AMP
1 AMP
.5 AMP
.5 AMP
.5 AMP
100 VOLTS AC
120 VOLTS AC
220 VOLTS AC
230 VOLTS AC
240 VOLTS AC
MODEL PS3- 1.5
Chapter 3 Installation Section