Speck Electronics EQ16 User Manual
Page 17
A few of the larger recording consoles that lack a patchbay may use two
jacks for the channel's insert points; one jack for insert output, and
another for the insert input. Most of the smaller rack mount mixers
mentioned in this manual utilize a stereo (TRS) jack for the insert points.
For these mixers it will be necessary to utilize a special "Y" cable with a
stereo plug at one end and two mono plugs at the other ends.
(See figure 5)
When patch points are not available, such is the case with many smaller
mixers, the source signal (synth/sampler or recorder) may be connected
directly to the inputs of the EQ16. The outputs of the EQ16 would then
be connected to the line inputs of the mixer.
It is recommended that interface cables be kept as short as possible and
only high quality cable and connectors be considered.
Power amp speaker outputs, microphones, guitar pickups, phantom
power supplies.
13
Things that cannot be
connected to the Model EQ16
Figure 5. "Y" Cable schematic
Chapter 3 Installation Section