Spectrum Controls 2080sc-NTC - Manual (Page 16)

Micro800™ 4 Ch Universal Thermistor Input Module 16
Publication 0100198-01 Rev. A
Module Error Register (MOD_STATUS)
The Micro800™ 4 Ch Universal Thermistor Input Module is available in only one
configuration: 2080-sc-NTC. The module uses the following parameters:
Bit Number Description Notes
0 to 1
These 2 bits define module operation mode:

0: Idle: Module is ready to RUN, and I/O is off.

2: Error: Error happens and I/O is off.

3: Busy: Module is busy, cannot go to RUN,
and I/O is off. See Notes.
3 is not supported
2
This bit defines module user interrupt mode:
0: User Interrupt is disabled.
1: User Interrupt is enabled. See Notes.
Always 0. 1 is not
supported.
3
Reserved
4
SW Error
Trigger condition.
The Watchdog
timer is triggered.
5
ADC Error
Trigger condition.
The ADC
communication
has stopped, or
the ADC has not
sampled data for
a long period of
time.
7
Configuration Error
Wrong bits set in
channel
configuration.
Input Block (0x20 [32] to 0x2F [47])
Register Address Comments
Input Data Ch 0 32 Channel 0 through Channel 3 (Signed 16-bit
INT)
Input Data Ch 1 34
Input Data Ch 2 36
Input Data Ch 3 38
RESERVED 40
RESERVED 41 to 47