Spectrum Controls 1794sc-IRT8I - Manual (Page 32)

3-6 Flex™ IO Isolated RTD/Thermocouple Module
User's Manual Pub. 0300242‐01 Rev. A
3.3.3 Add the Generic Flex Module
After adding the remote Ethernet communication module, the Generic Flex Module must
be added. The Generic Flex Module is required because there is no custom profile for the
1794sc-IRT8I module. The following steps must be followed to add the Generic Flex
Module.
1. Select a New Module for the I/O Configuration.
2. Select the module type from the Select Module Type pop-up.
Name the module
Select the comm. format
Enter IP address of ENBT
Select the chassis size
Select electronic keying level
Click OK
Select the module revision
level
Right-click on the local
communication module
Select New Module