Starrett 2000-24 Altissimo Electronic Height Gage - Manual (Page 5)

Setup
Starrett Altissimo Operation Manual Page 4 CAT 2000-24
1. Charge Battery - The Altissimo battery was fully charged at
the factory, however, the battery may have discharged during
shipping and storage. It is recommended to leave the charger
connected for at least fourteen hours. The charging circuit is
designed to provide a maintenance charge to the battery and
may remain connected for the duration of use. The tool will
remain ON while the charger is plugged in regardless of the
position of the Battery Power ON/OFF Switch.
Removing the Charger plug and reinserting will initiate
another charge cycle depending on the state of charge of the
battery.
If the Low Battery ICON comes on, locate the charger and
plug it into the Power Jack on the right side of the Display.
(Figure 3)
See Page 19 for additional Battery Charging information.
CAUTION - See Care and Maintenance section for necessary
precautions.
2. Move Slide - Rotate the Probe and Belt Locking Knobs
counterclockwise. Using the Coarse Adjuster Knob move the
Probe Mounting Arm to the center of travel. Re-lock the Belt
and Probe Locking Knobs. (See Figure 4)
3. Mount Probe Holder - Mount the Probe Holder onto the
Mounting Arm and tighten the screw firmly. (See Figure 5)
Note: Make sure the Probe Holder is mounted vertically.
4. Mount Probe - Mount the Probe into the Probe Holder and
tighten the screw firmly. (See Figure 6)
Note: Make sure the Probe Tip is oriented downward so that
the Probe Holder or the Probe Shank does not hit the surface
plate.
5. Clean - Clean the Probe Tip and the Top and Bottom
measuring surfaces of the Calibration Block with Isopropyl
Alcohol and lint free cotton cloth. (See Figure 7)
6. Lifting - Care should be taken when lifting the Altissimo.
Lock down the probe and belt (See Figure 4). Firmly grip the
unit by the base and outer casing. Avoid all contact with the
probe and display panel. Jarring motion may damage the gage.
Do not drop.