Summit Audio FeQ-50 Passive Tube/Solid State EQ - Manual (Page 8)

Basic Operation
8 Summit Audio, Inc.
1/4” TRS Balanced Tube Output
This is a -10dB, balanced 1/4” output designed to interface
with your recording device, compressor or EQ.
XLR Balanced Solid State Output
This is a +4dB, balanced, low impedance output connection
compatible with professional recording and audio equipment.
The Solid-State output provides a clean, low-noise signal.
1/4” TRS Balanced Solid State Output
This is a -10dB, balanced 1/4” output designed to interface
with your recording device, compressor or EQ.
Basic Operation
Setting up a Parametric EQ
1. Turn up the gain on the band you are working with. This allows
you to easily hear the effect of the filter.
2. Switch in the Narrow ( ) bandwidth setting.
3. Adjust the Center Frequency to “zero-in” on the frequencies
you wish to boost or cut.
4. Now that you’ve found the frequency you want, set the Gain to
a more conservative value.
5. Widen the Bandwidth, if desired, to create a more natural
sound.
6. Adjust the other bands as needed.
Important: For
proper operation of
the FeQ-50 (or any
vacuum tube device
for that matter),
allow the unit to
warm up with power
on for 15 minutes
before use.
Important: Do not
block the cooling
holes and allow
adequate ventilation.