SurgeX UPS-3000-OL - Manual (Page 22)

© SurgeX | Technical Support: 800-645-9721 | surgex.com Page 21
On-Line UPS User Manual
Models: UPS-1500-OL, UPS-2000-OL, UPS-3000-OL
SX-BDL-1500, SX-BDL-2000
B.
Startup Installation
1. Start and configure the UPS
On/Off Button Function Button Inquiry Button
• Press and hold the ON/OFF button for more than 3 seconds to turn on the UPS. The UPS
should now start its inspection of the internal functions, main synchronization, and inverter
startup. Then power should start to be supplied via the outlets. Once turned on, the UPS will
perform a self-test function, when the yellow LED turns to green, LCD displays “on line”, and
means UPS is working in utility mode.
2. Configure the local monitoring software if desired.
• Insert the UPSilon 2000 CD (included with UPS packaging) into the CD ROM of the local
computer.
• Select “Install program” from the Autorun menu and choose for the correct operating system.
• Follow the setup instructions. Enter the product key when prompted. The software key is found
on the CD cover. Click finish when prompted.
• The UPSILON icon will appear in the system tray of the desktop near the system clock. Double
click this icon to enlarge the program window.
• Connect the RS232 cable (included in the UPS packaging) to the Computer and UPS.
Communication should start momentarily. If it does not, click on Settings up on the UPSilon
toolbar, then select a different Comport until communication is established.
• Click on “Manual” in the UPSILON toolbar for further software configuration.
NOTE: PLEASE VERIFY AUTOMATIC SHUTDOWN TIME PARAMETERS IN THE SETTINGS
SECTION FOR YOUR SPECIFIC INSTALLATION.
3. Configure the optional NetAgentII SNMP card if installed.
• Insert the NetAgent Utility CD (included with SNMP packaging) into a PC and download the
user manual
• Install Netility from the AutoRun menu
• Connect a network cable from the PC to the SNMP card.
• Run Netility program and it will auto-search and list available NetAgents (SNMP card)
• Highlight and click “Configure” to change the network settings on the NetAgent discovered.
• Disconnect the cable to the PC and connect the SNMP card to your network.
• Access the SNMP card via the network and make configuration changes using the manual
downloaded previously.
NOTE: PLEASE VERIFY AUTOMATIC SHUTDOWN TIME PARAMETERS IN THE SETTINGS
SECTION FOR YOUR SPECIFIC INSTALLATION.