Power mode switch, Outputs, Main power switch – SVS PB12-Plus User Manual
Page 12: Power cord, Connectivity & panel operations, Svsound
© 2011 Specialty Technologies, LLC
•
Call SVSound
™
877.626.5623
•
www.svsound.com
SVSound
™
STA-800D/1000D Equipped Subs
Connectivity & Panel Operations
Power Mode Switch
The Power Mode switch allows the STA-800D/STA-1000D to either stay on all the time, or go into Standby
if no signal is being received. When in Standby mode and a signal is detected on one of the inputs, the
STA- 800D/STA-1000D will turn on and begin playing the material on its active input(s).
Outputs
There are two types of physical output connectors on the STA-800D/STA1000D; Balanced XLR and single-
ended with RCA connectors (also referred to as low level or line level). There are outputs for Left and Right
main channels for both types of connectors.
The output connectors are typically used to either daisy-chain additional subwoofers with single or dual unfiltered
outputs, or as the input to a power amplifier for the Left and Right main channels after using the High Pass Filter
and (optionally) Delay functions with two channel analog preamps (see discussion above under “Inputs”).
Main Power Switch
Use this switch to apply power to the STA-800D/STA-1000D amplifier.
Power Cord
Plug the power cord into a wall outlet. Do not use extension cords to lengthen the cord. Do not plug into
accessory outlets on the back of an AVR or pre/pro.
12