TracRac IM T-Rac Pro - Manual (Page 8)

8 T-Rac Pro INSTRUCTION MANUAL TracRac Inc. 994 Jefferson Street, Fall River, MA 02721-4893 • 508-677-4130
9. Now you’re ready to install the crossbar tie downs. Slide the tie-
down, T-bolt first, into the notch in the top of the crossbar and lock
them in place with the knob. (See Figure 6).
Notes:
For trucks with over the rail bedliners, follow steps 1 through 6 with
the bedliner off. Note the clamp locations and transfer them to the
bedliner. Cutouts should be approximately 3”w x 6”h.
Reinstall bedliner, repeat installation.
Although the T-Rac is capable of carrying a maximum of 750 lbs.,
evenly distributed between both racks, the capacity is limited to the
strength of the truck sidewall and road conditions.
See the matrix on included sheet for maximum load capacities.
For good performance and safety, we recommend re-torquing all
clamps and fasteners to the proper specifications after the first 500
miles and every 5000 miles thereafter.
Carrying high loads over rough roads with excess speed may damage
the system or your truck. Exercise good judgement at all times.
Please review the enclosed CAUTION sheet for additional guidelines.
• We’re confident about the structural integrity of our racks, but less sure about the strength of the new truck beds.
• The solution for greater capacity?
The Original TracRac System, which provides enough support for your truck to handle a full 1,000 Lbs.
Please call us with questions or concerns: 508.677.4130 or email: [email protected]
Figure 6. Crossbar Tiedown install
Accessories Available
Toolbox Mount Kit for mounting your toolbox KayakMount (4) for carrying canoes and kayaks
T-RacPro
_IM_
T-RacProT-RacPro
1.10.06