Vermona PERfourMER MKII - quad analog synthesizer - Manual (Page 19)

NOTE Changes from one scaling factor to another will take
place after a waveform cycle has been completed. Do
not worry about a possible delay after switching at
slower tempos - this is intended.
Internal MIDI-CLOCK
The PerFourMer MKII can also generate an internal clock to synchronize the
LFOs. Its tempo can be adjusted using a TAP function.
To use the internal clock as LFO clock-reference, follow these steps:
1. Press the EDIT-button.
2. Select parameter 9: INTERNAL MIDI CLOCK using the SELECT/SEQ
control.
3. Press TRIG to enable the internal clock-synchronization. The corre-
sponding red LEDs above the TRIG-buttons will display the synchro-
nization status. This is a global parameter, valid for all synthesizer
channels.
4. Exit edit-mode by pressing the EDIT-button.
To change the tempo for the internal clock signal, follow these steps:
1. Press the EDIT-button.
2. Select parameter 10: MIDI CLOCK TEMPO using the SELECT/SEQ
control.
3. Press any of the four TRIG buttons to TAP the tempo. The TRIG LEDs
will be blinking with the current tempo. The new defined tempo will be
set after four taps.
4. Exit edit-mode by pressing the EDIT-button.
Owner's Manual VERMONA PERfourMER MKII
- 19 -