Vermona PERfourMER MKII - quad analog synthesizer - Manual (Page 25)

Programming Section
The rightmost section of the PerFourMer MKII's panel serves to adjust the
MIDI-channels, EDIT-parameters and PLAYMODES with the addition of
global controls for MASTER TUNE and MASTER VOLUME.
Combining Multiple Synthesizer Channels
The four PerFourMer MKII's synthesizer channels can be combined in differ-
ent ways. Depending on the selected PLAYMODE, the synthesizer channels
can be played monophic, duophonic or polyphonic.
To combine synthesizer channels, simply set them to identical MIDI-
channels.
To do so, carry out the following steps:
1. Press the MIDI CH-button.
2. Select the MIDI-channel (1…16) using the SELECT/SEQ control.
3. Press one or several TRIG-buttons to assign the corresponding synthe-
sizer channels to the selected MIDI-channel. The corresponding red
LED above each TRIG-button will be lit.
4. Exit MIDI-mode by pressing the MIDI CH-button.
NOTE Steps 2 and 3 can be altered at any time until the
edits are confirmed by leaving the MIDI-mode.
PLAYMODE
PLAYMODE determines how combined synthesizer channels react to incom-
ing MIDI-notes. The mode specifies if and how a synthesizer channel will
react to a MIDI-note. The modes are selected using the PLAYMODE control.
The following six modes are available:
MONO 1 (M1)
With this PLAYMODE enabled, all combined synthesizer channels are
regarded as a singular monophonic synthesizer. All combined channels are
played in unison.
In addition, Mono 1 is the standard-mode for all synthesizer channels not
being combined. With
channels 1, 2 and 3 being combined on MIDI-
channel 10 and channel 4 reacting to MIDI-channel 11, channel 4 can be
Owner's Manual VERMONA PERfourMER MKII
- 25 -