Vermona PERfourMER MKII - quad analog synthesizer - Manual (Page 21)

Legato
Each of the PerFourMer MKII's synthesizer channels allows its legato-mode
to be enabled independently. In legato-mode, the envelope generator will
not be restarted when note are played overlapping.
To enable/disable legato-mode, carry out the following steps:
1. Press the EDIT-button.
2. Select parameter 6: LEGATO using the SELECT/SEQ control.
3. Press one or several TRIG buttons to enable/disable legato-mode for
one or several synthesizer channels. The corresponding red LEDs
above the TRIG-buttons indicate enabled legato-modes for the
channels.
4. Exit edit-mode by pressing the EDIT-button.
Connections of the Synthesizer Channels
Each of the PerFourMer MKII's synthesizer channels has two TRS-jacks that
offer two functions each. The function we consider the most frequently
used is available on the tip contact, so that you may use common TS-
cables.
The second function is available on the ring-contact and can be addressed
with an insert-cable (Y-cable TRS to 2xTS) .
EXT IN / VCO OUT
This jack allows feeding an external audio-signal into the synthesizer-
channel. This signal can be selected using the WAVE-selector switch.
(See page 7).
The ring contact will output the pure oscillator signal, unaltered by the
filter and VCA.
OUT / INSERT
This jack primarily servers as individual output for the corresponding
synthesizer channel. However, using an insert-cable, this jack will pro-
vide an insert for external effects such as a ring modulator or special
filters.
Owner's Manual VERMONA PERfourMER MKII
- 21 -