Wyred 4 Sound mini-Integrated User Manual
Page 8
Page 8 of 16
of the crossover should then be routed to the Main In input on the mINT. The signal
fed to the Main In input will then be fed to the amplifier.
The Fixed Out feature is activated by selecting the “out position” on the 2
position switch. If fixed out is selected the mINT can be used for recording or to feed
a signal to another system. The fixed out is 2.0V. This is a configuration switch and
must be set with the mINT powered completely off!
DC Trigger
Near the middle of the rear panel is a 12V DC trigger in and out. If the HT
bypass is not active the trigger In will turn the unit on from a standby state
(illuminated green around the power button) and it will default to that last used
input. When HT bypass is active the trigger in will power the mINT on directly to the
Aux 2 input (HT bypass). Trigger out will be active whenever the mINT is powered
on. (Current Rating 20mA)
USB Configuration (MAC)
When connecting to Mac computers the USB interface automatically installs
the drivers into the operating system. If you are using a PC, drivers are required for
asynchronous operation and they are available for download on the Wyred 4 Sound
websPlease refer to the next
section regarding USB setup for PC. If you are using a Mac please follow these
directions.
(Please note: This USB device currently does not support Mac OS 10.5 or earlier)
1. Connect a USB cable from the mINT to the computer ( type: USB A to USB B )
with the mINT and computer powered on.
2. The USB device should automatically start installing.
3. It is now necessary to select the mINT as the output device. Please locate the
Audio Midi setup by following this directory: Go to Finder----> Applications--->
Utilities----> Audio Midi setup. Once you have reached the Midi setup you will
need to select the “24/96 Async USB Audio Sound” as the default output
device and apply the setting. This can be done by clicking on the device listed
above, followed by clicking the “gear” icon located at the bottom of the
window. When you click the gear it will show a pop up window where “set
default output device” can be selected.
4. Now you can open your preferred music playback program and find the
preferences or options tab. Once you locate the output device, make sure the
“24/96 Async USB Audio Sound” audio interface is selected. It is not necessary