G-Shock MRG-8100B-1A - Manual (Page 75)

74
To trigger the auto hand home position
■
correction operation manually
Perform the following procedure when the time setting is off. • •
In the Timekeeping Mode, hold
down D for about six seconds
until the second hand completes
one full revolution.
Though the watch will beep and second • •
hand will stop momentarily about three
seconds after you hold down D, do
not release the button yet. Wait until the
second hand completes a full revolution
before you release D.
The watch will perform hand home position correction
automatically, which takes up to three and a half minutes to
complete. Do not operate the watch during that time. The watch
will return to regular timekeeping after auto hand home time
correction is complete.
To interrupt an ongoing correction operation and return to regular
• •
timekeeping, press D again.
If you release
• • D when the watch beeps and the second hand
momentarily stops after three seconds, the watch will go into
manual home position correction, which is described under
“Manual Home Position Correction” (page 75). If this happens,
press A to return to regular timekeeping and then perform the
above operation again.
The manually triggered auto home position correction operation
performs the following two steps.
The hands will move automatically in order to determine their 1.
home positions.
After auto home position correction is complete (about three
2.
and a half minutes), the watch will return to regular timekeeping
automatically.